More Sun ok> Prompt Commands

Courtesy of a Sun v120.

Use the following to determine the mac addresses of each interface
ok>devalias

The command above returns the following
rootdisk                 /pci@1f,0/pci@1/scsi@8/disk@0,0
lom                      /pci@1f,0/pci@1,1/ebus@c/SUNW,lomh@14,200000
dload                    /pci@1f,0/pci@1,1/network@c,1:,
net2                     /pci@1f,0/pci@1,1/network@5,1
net                      /pci@1f,0/pci@1,1/network@c,1
{truncate}

Then you can cd to the path for either net or net2 and run the following command
ok> .properties

This command returns the following for mac address
local-mac-address        00 03 ba 96 38 c0

In this case I was working to troubleshoot a jumpstart install, so I needed to see what mac address was being presented externally.

ok>printenv

printenv reveals that local mac address is set to true which means that each network interface presents it own mac. Being that I was plugged into nic 0 on this box i am also able to boot like so.

ok boot /pci@1f,0/pci@1,1/network@c,1:dhcp - install

Being specific in this way, I am taking any way chance that I have the mac address incorrect, or am plugged into the correct ethernet port.

I can verify which port has my link by doing the following from the ok prompt

ok watch-net
Internal loopback test -- succeeded.
Link is  -- up
Looking for Ethernet Packets.
'.' is a Good Packet.  'X' is a Bad Packet.
Type any key to stop.
............

If I try this on net2 is see that this link is down

ok watch-net2
Internal loopback test -- succeeded.
Link is  -- down

Comments

[Shiva]

I did understand ur answer can you please give me a brief disription about my question

[Christopher Paquin]

What is your question. I do not see one

[ashok]

hi sir

[RAMESH]

hi ,how will find out howmany CPUs in server.can anybody tell me how can see from the OK prompt.

[prabu]

From OK prompt run .speed will show you the CPU and PCI bus speeds
example:
.speed

[ZeeUSA]

Hi every one I am new to Solaris I want to know hwo, how i know my machine has hme0 or eri0 or any other adopter name? at ok prompt.... for the perpuse of jump start boot entry in boot serversysidcfg file.

[Christopher Paquin]

Try this:

>show devs

This will give you output like this for your network interfaces.

>/pci@8,700000/pci@2/SUNW,hme@0,1

In the case above you would have and hme interfacce